Underrun protection for the VW T4 model, all wheelbases, all engines, 2 and 4WD.
The tank underrun protection connects to the existing original engine tray or an existing accessory steel underrun protection and prevents sharp objects from penetrating the tank. In addition, the part of the cardan shaft that runs under the tank is protected.
Emphasis was placed on a balance between weight and stability because it should be easy to dismantle even away from the workshop.
Thanks to the full-surface powder coating (black), it is particularly well protected against corrosion.
The mudguard itself is made of 2 mm steel, equipped with 8 roll beads to avoid vibrations and increase stability. Otherwise it is smooth and almost close to the tank so as not to lose ground clearance unnecessarily.
It has 2 correspondingly large recesses from below in order to adjust/relax the torsion bars using a possibly existing nut.
The 3 holding plates are made of 2mm sheet steel, also powder-coated.
The protective plate is connected to the brackets using stainless screws.
Assembly: In order to assemble the retaining plates, the tank straps must be loosened in some places. To do this you have to support the tank; a hydraulic ram is ideal for this (either a car jack or, if using a lift, a transmission jack).
Underrun protection for the VW T4 model, all wheelbases, all engines, 2 and 4WD.
Set includes:
- Protective plate
- 3x retaining plates, 1x baffle
- Screw set V2A
- Installation instructions
| Item weight: | 20,30 kg |
| Dimensions ( Length × Width × Height ): | 120,00 × 120,00 × 5,00 cm |
